Recent content by raymondtm

I have this manual, but does anyone have a complete set of instructions about how to operate and step through ALL the settings and diagnostic readings?

Thanks!

After having this same problem and was unable to correct had a pool guy come out to check the panel. Was told that one setting on the panel should read T19 and it had been set at T3. Not sure how this happened but it has happened again. Does anyone know how to reset the T level reading?

Ok, good, thanks!

Sorry for the wide open question. I brought this question from another topic about the Hi Salt light on all the time. So, the problem is the Hi Salt light stays on. I have let out some water a couple times and put in some fresh. I don't know if maybe it wasn't enought fresh water, or if the...

How can you tell if the Aqua Rite panel is defective? What are the troubleshooting steps, if any? THanks, Raymond

The High Salt light is still on. I drained and added some water. May have to do it again. But, three questions, please: 1. The High Salt light started all this, and low chlorine in the pool, and I hadn't added any salt lately. So, how did the pool get too high a level of salt? 2. Can't...

Thanks, JasonLion. Should I be running the system now in the normal on position while it's getting the 24 hour average, or should I turn the system off a while (24 hours)?

Ok, good to know, JesseJames, thanks. Just for clarity, on my panel there are no blinking lights, only a solid red light, High Salt. I have shut the system down and restarted. Also, turned the power completely off to the system, just for grins and to get a complete 'reboot'.

The salt was tested at 3700, which probably meant that High Salt light should have been on. We put in the chemicals recommended by the supply store, and also drained some water out of the pool and refilled the water to proper levels. Maybe we didn't drain enough water? Maybe we did, but it...

Good question and problem. I am here because I'm having same issue. System been working fine. Couple days ago, the High Salt light staying on. Tested water, no chlorine. Went to supply store, bought all necessary/recommended stuff, put in pool. Water looks and tested good now, but the High...

Thanks for all the tips. My 380 quit rolling this weekend. Began troubleshooting. I noticed the wheels were not turning. Also, I turned the unit upside down, and noticed the front water jet (of the three jets in the throttle) was not pumping near as strong as the other two jets were. So...