Recent content by quickslvr

Just a quick follow up / status update. I'm pleased to report that I think the problem has been resolved! After unplugging all three com ports from the surge board, the system did not reboot. However, after attaching a single com3 (Chlorinator) the system started rebooting again. I replaced...

@Jimrahbe @ogdento First- I'm incredibly grateful for you time and expertise. It's greatly appreciated! Per your guidance, I disconnected COM1, COM2, and COM3 from the surge board. The system ran all day (well from noon anyway) with NO reboots! This evening I went back out and connected the...

Thanks - I'll test those other items tonight. Last night I disconnected the SWCG so the system could run on the automation today without it -- to see if it was still rebooting. This morning when it didn't turn on at the time it was supposed to, I found the 12V circuit tripped. This happened...

I tested the voltage at the COM port on the main board. The system is “on” but nothing is running. The voltage shows 15A. It might prove to be really challenging to get a reading of this at the instant the reboot happens - sometimes it will run for 3-4 hours and not reboot. Sometimes it will...

Thanks guys - much appreciated. I'll brush up on my multimeter skills and report back... Removing the salt cell from the equation is easy enough... however, I will point out that I did replace the salt cell earlier in the summer. I was previously running an IC40 that seemed like it had trouble...

Jim - I really appreciate your input and ideas. I apologize for the delay. I *thought* I had this fixed, but unfortunately I do not. In the last month or so, I have replaced - EasyTouch UOC Motherboard 520657 (Pool & Spa). This had died thru this, whether it was old age or possibly "burnt...