Recent content by phipsi1237

Whoever tests this out, let me know how it works. Haha

Mine runs over constantly. I don't think it affects ph/aeration much, which I think is most peoples concern.

Yes. I would guess that the main power line comes up from the ground into that box, then to the timer and light. I would bet there's a breaker inside that box.

The breaker for my pool is in the same box as the rest of the house.

I try to read or skim every post on TFP via the unread posts option. It takes a lot of work to keep up with. I was just curious of the average number of posts per day or month or whatever. Does the forum admin/mods have any stats on this? Thanks, Billy

Richard, Unless I'm missing something, did you post the wrong link?

I run normal filtration/swg at about 1100 RPMs. Would be fine lower, but that's what keeps the heater from low flow error. I ramp it up to 3000 to run the cleaner.

Tftestkits.net I believe it's made by Taylor.

Welcome. Start with pool school and ordering a good test kit.

I had to make sure I got all the sealant out from around the wire exiting the niche. There was lot that was holding it in place.

The last set I ordered before upgrading the whole filter, I ordered from http://www.poolfiltercartridges.biz (filters4less on amazon). I'm guessing they were generic, but they seemed to work fine.

I have the easy touch as well. Love it. I went with the ScreenLogic over the Autelis after a lot of research, but can't remember the deciding factors. I don't see how you could be disappointed in either setup. When I upgraded my equipment, Pentair had a deal for extended warranties for...

When I found this site, I immediately went and bought bleach, baking soda, and borax. I'm fairly certain I never used the baking soda or borax. I think that's the point jblizzle was making. I've found that bleach and muriatic acid are really the only items I need to keep on hand. Since the...

The last house I rented, the owner had a pool service that I was responsible for paying. After the first time they came out and I saw what little he did, I said no way I'm paying for that. That's when I joined TFP and fired the pool company!!!

I think Pentair sent me a check valve to install on the IntelliPh that's supposed to help. Also, it should be fairly easy to extend the tubing so that the connections aren't inside the housing. I'm just not there enough to deal with it. Pentair's support has been great though.