P
Latest activity Postings Media About
-
-
Ppgrovetom replied to the thread Jandy iAqualink 3.0 and lost control over solar JVA.I removed the red/black wires from the solar sensor connector block and measured the resistance from red to black. It was open. I'm...
-
Ppgrovetom replied to the thread Jandy iAqualink 3.0 and lost control over solar JVA.Great ideas. I suspect you are right. I have an electronics background so I could just use a resistor or 10K POT in place of the solar...
-
Ppgrovetom replied to the thread Jandy iAqualink 3.0 and lost control over solar JVA.You are correct. The red/black wires on the upper block that says solar go to the solar sensor on the roof. On "other devices" there is...
-
-
Ppgrovetom replied to the thread Jandy iAqualink 3.0 and lost control over solar JVA.I believe since my Jandy was an old 2001 version, its solar JVA connector is above to the right side of the manual buttons. This is...
-
-
PI had an old Jandy RS16 based system which I had to upgrade from a single speed filter pump to a variable speed pump. I had my system...
-
PI replaced a very old Kreepy Krauly with a Polaris 280 and the 280 had such a small vacuum opening, the oak leaves just plugged it up...
-
-
Loading…
-
Loading…
-
Loading…
