Recent content by paulb0820

Was hit with the "No Cell Power 2" error message on my Hayward AquaRite Pro. While I sort that out, I'm using some powder to chlorinate my pool. Questions are; -Should I hit the Run/Stop on the AquaRite Pro for the time being until it gets fixed? -Is there any concern for the T-Cell...

Thanks! It says 3 year warranty. From your link, it sounds like I'm good. Thank you!

Okay, (hopefully) last question for a while. I just ordered my replacement T-CELL-15. I ordered through Leslie's as it seemed they were $899 everywhere so figured I would get some rewards points to use later (and delivery seemed quickest). The one I ordered from Leslie's says it is a Hayward...

Thanks guys. Long time listener and first time caller. Appreciate all you do here!

Move the switch from auto to off and check all of the readings. (No readings shown when off.) Move the switch back to auto and recheck the readings. 29.60V, -1.15A, 87, 0000PPM Move the switch to off for a minute and then back to auto and recheck the readings. 27.53V, +3.99A, 87, 1200PPM

So should I unplug the current cell until I get a new one? Might be a couple weeks as I wait for a credit card to close and I worry I could damage the SWG board if the cell is struggling and using the wrong amount of volts/amps.

2014 according to the serial number. Yes, it is clear and I cleaned it just to be sure.

Getting the low salt light on my SWG system. It is showing 1200 for average salt and a manual test is 3900 (added a little too much before discovering the issue). With that ratio, I'm guessing the cell is probably about done. Serial number is 3E14308, so I have gotten a decent amount of years...