Recent content by NVSean

Thank you very much. I had read to remove the heater and re-install again in the configuration mode, after confirming which LVR. It took several reboots of the system for it to actually work, but finally I was able to control my Hayward heater with my OmniLogic App and controller. What a...

Thank you for your posts. I had similar issue, in that I had an electrician install heater, but I needed to change the relay. At first this did not work so I ran a new 2 wire cable to connect the heater to LVR1. I had to delete the existing heater in Config Wizard and then install a new gas...

Similar issue- electrician wired heater 240 directly to breaker in the box and 2 wire to control board. I cannot get the heater to turn on through the Omnilogic board or app. Even when the heater is in standby mode or “bo” mode, the controller does not tun on the heater. I can turn on the...

Thank you for sending this guide. I am still trying to troubleshoot the issue. no response from multiple emails and calls to Hayward. The original install company was bought by Leslie’s and they have “no clue” as per the technician. They do not directly support Hayward Omnilogic, even though...