Recent content by nuke_twidget

Thanks for pointing that out. Completely forgot to add that!

I have an intellicenter control panel, but no real automations set up outside of the basic pump schedules.

I'm in the process of ordering a new stack flue sensor for my MT400 and the tech that was out today suggested I upgrade my control board as well. He spoke pretty highly of the new 6 button panel over the older model. I installed my current MT400 in late 2020, so just before the cutover to the...

Dumb question. When we built the pool, we already had a robot so they never showed us how to use the suction cleaner. What do the valve positions need to be in order to use it? Is there a way I can prevent what it picks up from entering the filters? I've gotten used to not having to clean those...

Looks like my motor went out on my Prowler 920 after 3 years. It's only running for a few minutes before it stops and subsequent attempts to start it has no effect (the light on the robot won't even turn on). I'd prefer not to drop $650+ on a new motor and would rather go another route if...

Perfect, thanks!

Finally checked the robot I have. It's the Pentair Warrior SI. Should I be changing where I'm drawing water from based on those valve positions?

I can't remember the exact model, but it's a private labeled dolphin that came highly recommended from here. Glad to see I'm at least heading in the right direction. The good news is, it's three off season.

We never purchased a suction side cleaner, but I do believe it is plumbed for one. I'm assuming that's what the valve labeled "cleaner" is for. We've exclusively used a robot since day 1 and never touched those valves after the pool install. I'm happy to purchase a manual cleaner to do the job...

Recently I drove a T-Post right through one of my returns which has led to a multi-day repair in between my normal job. We've recently had a ton of rain and while the pipe was open, some of the muddy water found its way into the pool. The repairs are complete and now I need to get my pool back...

I found out that even though I turned off the individual circuits from freeze protection, the panel still indicated it and overrode it. I temporarily raised the temperature sensor to 50F and were back to normal. Now to get the water clean again!