Recent content by newbie_pool

Hi, I just want to follow up on this to see if anyone came across similar issue. At first, I thought it is working again, however, it ran for line few minutes and stop. We have to use the Prowler app to run manually then it works but we have to stand around there and manuaver the robot around...

Is there reset button after lift the motor up? Or lift up and off its connector considers as reset?

I followed the video and it seems unscrew and rescrew, would that reset the motor?

Thank you all for all the suggestion. After taking the impeller apart and did some cleaner, it seems the impeller can spin now after several tests. I tried a few time more and see how it is under the water. Everything else check so hope for the best.

Here is my second attempt to turn on, this time the impeller does not spin anymore. I can see the wheel spinning back and forth. So is our impeller gone bad?

I have no idea what to expect here. Does this mean something? Should it run continuously? I first turned out and it seems like it runs for about 20 seconds or so and then stop.

Do these look ok? I don’t see any slop but once again, I might not know what I am looking at.

Thanks for your suggestion. I didn't actually remove the impeller, I just open enough to see the impeller to make sure there is nothing stuck there. So I assume I can just turn on the robot and see if the impeller is running? Since the wheel kit is out of stock, how can I tell if my current...

Hi, We purchased our Warrior SI from Marina pool almost 3 years ago and now it stopped working. Basically, it worked back and forth for a little bit and then stopped running. We installed this Prowler app to our phone to remotely run the robot and when we looked into the app, it displayed...