Recent content by munsoned10

My mpv is on the side so I didn’t take it off. I just assumed if I had it turned to the close position that would have been ok?

I just opened it so it is pretty green. I am not able to see the bottom. Would the filter be building up pressure if lateral lines were damaged?

So mm Yes, I always wait until the pressure drops and no, I never change the mpv while motor is running. When I was deep cleaning the sand filter the mpv was in between settings where the pool closers had left it. I changed it to close. I then continued running water into filter. Could these...

I just deep cleaned my sand filter. I tried to be careful as I moved the hose around the bottom of filter. Today I noticed sand in the road where my pool drains during a backwash or waste cycle. My question is this a common occurrence after the deep cleaning or have I possibly damaged a lateral...

I’m leaving tomorrow on a week long vacation. I worry about leaving pool pump running. I have a new pentair superflo vs pump and a Triton II TR 60 sand filter but my plumbing is 20 years old. Should I just turn it off and fight the algae bloom when I get back or not worry and run it?

Thanks Bama Every summer since I moved into this house, I‘ve tried to figure out what it was called. Wonder if it would hurt the plumbing if I plugged it? The steps are the furthest jets from my pump, so they get the least amount of pressure and I get a lot of debris on steps. I tried using 3/8...

Trying to identify this pool part and its purpose. It is located on the deck next to pool stairs

Thanks for the quick responses

Yes there is a jet that it appears to connect to.

Anybody have any idea what this part of my pool is or what it’s use is? It has a screw on cap and appears to be a pipe leading into the pool by the steps. We have lived in this home about 5 years and always wondered.

I recently purchased a TigerShark QC. My problem is even with the Thrust Restrictor Plate installed the cleaner still climbs too high. It also makes an excessive clinking sound, intakes air into the bottom inlet, falls off the wall rather than reversing back down. Help!!!!