Recent content by MrTilly

Needsajet, Thank you! Excited to be here. Chris, I did validate that my chlorine generation level settings persisted through a power cycle, after setting and leaving the SWG powered. The vendor recommended 10 minutes post setting change, though I can't validate, I left mine for several hours...

Matt, Thanks for the heads up!! Will leave the SWG wired as manufacturer directs, to be powered only when the pump is powered.

From Solaxx (PureChlor vendor): Is this a new installation or have you had this system for a while? This usually happens during initial setup if the system is programmed and then shut off too quickly. You need to set the program and then leave the system in that setting for approximately 10...

Hey Chris, I'm slacking, and resorted to unplugging the salt cell for the past couple of weeks to let the chlorine levels drop. It's interesting that yours is defaulting to 1/8th where mine defaults to 5/8. I'll send the vendor a note this evening, referencing this thread, and will share any...

It defaults to what I'm assuming is 5/8th of maximum chlorine generation (5 dots lit on the 8 dot "Chlorine Level" scale). Additionally, and when tested separately, the "On/Off" setting defaults back to "On", and the "Super Chlor" setting defaults to "Off".

Hello, I have a PureChlor SWG that is generating too much chlorine (FC ~10ppm) now that the weather has cooled off in Phoenix. The unit has an adjustment for chlorine generation (in addition to on/off, and "super chlor") though all settings are reset to default each time the pool pump starts. It...