Recent content by Mchristo

Thx James I sent my second post before seeing yours. Any idea where I can get instructions for how to replace the sensor? Thanks again.

Additional info: I just tried to reset everything by shutting the power off to the whole system (just like the IT guys telling you to remove the battery from your laptop when it doesnt work. 😂). Waited about 30 seconds and turned everything back on. This time the JXi display said the water...

I’ve got a JXi gas heater that won’t turn on. On the IAquaLink it appears as though it starts and is running, however doesnt start up at the equipment. The pool water temp on IAquaLink shows 71 degrees and that is accurate. On the Jandy JXi display it shows the water temp is 108 degrees...

We have an AquaLink Touch RS-8 Combo installed in 2017. After a pool party yesterday I noticed the pump was not running. All skimmer baskets and pump baskets are clear and were clear when the breaker tripped. (They were cleaned out just prior to the party and were still clear when this issue...