Recent content by MadRed

Let’s see how my signature looks?

Here is a picture of a panel. I think left side breakers may have been slightly moved. And right side has the heater. Also, all lights are now LEDs sitting after transformers. And the pump is IntelliFlow punt connected to IntelliCenter.

1. Single 2. I’ll take it later 3. No Load center. I have IntelliCenter LITE 4. I’ll take it later Doesn’t the making on the switch means 120? Or does that mean 120-277?

This switch was there before IntelliCenter. It controlled pump only. It’s a kill switch that pool service uses to turn off the pool pump. So I am not sure how it is wired but every time my IntelliCenter disconnects, I flip that switch for 20 seconds and back. IntelliCenter jumps back online. I...

It’s 20 amp 120 277V

I already have a manual kill switch by the equipment. I was thinking of replacing it with smart switch. Original is 20 amp, the one I bought is 15 amp Leviton switch.

What about smart WiFi switch where there is a manual shut off switch?

Don’t you wish they had a remote restart or scheduled restart? This way I would not need to drive to my rental house to use my remote system.

Great point. Not my ideal approach. Is there a way to figure out the reason for disconnect?

I updated my IntelliCenter to 3.002 and now it loses connection to the cloud one a day. I had to physically restart it to get it back online only to go offline in some short time. I had similar issue with 1.64 but much much less frequent. Maybe once a week. I recorded a video and sent it to...

Is it possible to obtain 2.017 to try? I have very simple setup. Lights, pool and spa. Just want to see if I can get this bug resolved. I had an installer put it in. He was a bit of an a55 and did not like all the questions, so he is not a good resource. I figure trying new firmware may...

I wonder if WiFi power adapters are rated for high AMPs. Also, my firmware is at 1.6 something. I know there is 2.+ version but it does not show up in the firmware update on the IntelliCenter.

Not sure if you were pointing to something specific. I have searched and read but did not see anything like my issue.

So I’m assuming I am not a first one to experience that? Also, it sounds like even if I had a direct wire connecting IntelliCenter and router, same would happen. Is there a way to remotely reboot or schedule a reboot of the IntelliCenter?

I am having the same issue with power wireless link. It works for a week and then stops. The only way to restart it is to restart the IntelliCenter. Which defeats the purpose of remote operations if need to go to the physical location to restart it. Any help is greatly appreciated.