Recent content by lodi

@JamesW thank you! That’s exactly what I was looking for. I should’ve done a little more research on my own. Appreciate the information and the link.

Have replaced my trusty Jandy pool lights 2.5 times in 10-years and I now have to replace half of them (four lights). Right now, every light is a JLU4C6W100 (6 watt). The pool looks great but I definitely have some dark spots. Since I have to replace some of the lights I want to consider 12W...

I Just figured it out. I did not realize that iAqualink had a different temperature sensor that the JXI heater. Just ordered the iAqualink sensor and feel confident that it will resolve the issue. Thanks for your help.

Just thinking…. Does the heater have a separate temperature sensor internally? As far as I can tell the heater is displaying the correct info. It’s only iAqualink that is off by 8 degrees after I calibrate it to its lowest setting.

I will order one now. Stay tuned…

OK, thank you for the clarification on the temp sensor. That makes perfect sense. The first thing I did when this problem cropped up was replace the temperature sensor. It didn’t change anything. At this point I think the issue is somewhere in iAqualink. I need to do a bit more testing when...

I looked at the manual and cannot find anything obvious. I did a little testing this morning so I have a better handle what’s happening. Issue 1: Spa out of calibration with iAqualink and JXI Heater. Turn spa mode and heater on from iAqualink. Everyting looks fine on iAqualink app screen...

You’re absolutely right. When I go into the web interface to calibrate the temperature it shows Pool Temp 91, and says NA for Spa, like my Spa is offline. I will look at the link you sent me. Thanks!

Have a Jandy JX pool/spa heater that does not get to temperature. If I set the spa to 104 the water gets to low 90s. Water flow seems good, the heater fires without a problem and I replaced the temperature sensor. It seems like a calibration issue, however, when I go into the calibration...

It is. I think I’m gonna replace the thermostat and see if that works. Everything else seems to be in order.

I haven’t changed any values on iaqualink Automation UI. I just went in and checked to ensure this to be the case. I will say that the spa will read at 104 on the mobile app but the water is probably 20° cooler.

I guess that would be the iAquaLink system. It has a wireless connection at the pool equipment. Then I connect through the mobile app or a web browser.

None other than the Jandy mobile app.

I have no idea where I got that from. Its a Jandy JXi. Sorry! I will update the original post.