Recent content by locutusut

I found the issue. There was an "external" program enabled that, once disabled, stopped the running out of schedule. Still not sure why, but that was the reason.

If I press start/stop twice (twice to turn on the green light), the pump turns on program 3, which I currently have set to Manual. Only Program 2 is set to Schedule. The reset button on the panel seems only to reset alerts. Is there some other way to reset the pump? Thanks, Lou

I have a Pentair VSF 011056 pump, and I have three programs but recently disabled two of them over the winter months that would typically run during the day. The remaining program is set to run from 12 AM-6 AM; however, I'm seeing the pool pump continue to run outside of this schedule on this...

I recently had a Pentair VSF 011056 pump installed and connected to my Pentair SolarTouch panel. My solar system is on a two-story roof and is about a 450 sqft system. I've noticed some odd things different from when I had my solar running standalone with a single-speed pump previously. The...

Thank you and thanks for the advice. I'll turn it off then too. I've been using Pool Calculator to figure out how much bleach to add. Yesterday it said add 50oz of 10% bleach to get it from 1 to 3 ppm, which I thought would be a little much for the cold water temp. I looked at the chlorine...

I'm torn whether I should run my new solar pool panels during the colder months. Right now the water is hovering around 58-60 F, which is the bottom of the range for my chlorinator to produce any chlorine. I could turn it off to keep water out of the panels in case of freezing or on the other...