Recent content by ldcsteelers

I bought a new IC40 to replace the old one and it didn't fix the problem. That's when I started this post. I called Pentair based on recommendations here. They sent someone out with a new flow switch but that didn't fix it so they ordered an new IC40. When the tech came out he also brought a...

Yep that's it.

Ok quick update. Turns out it was the Surge board that was bad. There's not much on there except a bridge rectifier and a few passive components but it's still $200. :o Output voltage was 36V on the new one as opposed to 42 on the bad one. Thanks everyone for your help. I hope closing this...

No LEDs for the hours (it is new so that was expected) but the CELL and FLOW lights were Green. The Temp was 80% which is accurate

Jim I would be much more comfortable with that answer if my SWG cell light was green. Is there any way to check salinity levels from the SWG itself? (Oops that was kinda dumb. There are idiot lights on the panel for low and high salt levels)

Taylor K-1766 Test kit plus Pool Store

The Salt level light is reading too low (RED) and the unit is not producing. The Cell light is off.

Yes its set to ENABLE YES and I was even able to adjust the Percentages and the lights on the SWG reflect accurately the settings

I just replaced my orginal IC40 with a new one because the original was reading 0 salt. The story is deeper than this. It started when the comm system on my eztouch went out and so I replaced the eztouch motherboard. That got my pool pumps working on schedule. Also my Internet interface...

Today's pics... Should I keep it?

Well it turns out that the Pool Finish installers screwed up and applied WetEdge Pacific Luna Quartz, a product my PB isn't even authorized to sell!!! For safety reasons we have to get water in the pool and figure it out later. So 24 hours and 3 hoses later... - - - Updated - - - it...