Recent content by kwing01

Yes, it can read, no, i didn't disassembled. only thing i see wrong is there are little water leaking from tank and flange adapter, but i googled, if it is leaking, the psi should down and not up.

when rinse it is same psi as the backwash. Just filter is back to normal to 21.

We closed it when open our pool, so the water will go to the heater.

yes, it is 0 when it is off.

before backwash and after backwash are same 21 psi, just start with backwash is going to high to 29 psi. Also i see there are some water leaking between the tank and FLANGE.

Hi, This year, when i opened my pool, when i try to backwash my pool, my sand filter pressure is high as usual. In the past when i backwash my pool, it is normally 21 psi, but this year when i backwash, i see it is going to 29. Could you let me know what wrong with my sand filter?

so is it no way to replace the o-ring?

Hi, Anyone know how do i open the circle base to replace the O-ring?

Could I put some sand back in skimmer and let it return to the filter? Did it hurt the anything?

Hi, I replaced 2 speed pump few years before, I believe my new pump is little overpowered than the old one. When I backwash, I see some sands are out with the water. My question is could I backwash and rising using low speed?

Hi, Anyone know how to clean the rust on the pool ladder? Look like it is paint? and what kind of paint i can repaint it? image1 — imgbb.com image2 — imgbb.com