Recent content by kpinpoway

It coulde be my Voltage meter skills but yah it's contradictory. Anyhow I hooked up a brand new actuator to each output on board....no power/functionality =(. Thank you for repling.

I have a polaris eos 3 control panel with no power to the actuators. coming out of the board I seem to get voltage but actuators have no power? Anyone else encountered this?

Are filter unions interchangeable across brands? Also can you plumb the outside with 2.5” coupler?

I got 2 120 volt pool lights. rather than pay $3-400 for pool specific bulbs. I dont see any reason why some regular LED bulbs wont be ok?

So as fate would have it I drained and refilled 2 pools this week. On both of these accounts the home owner was out of town. So I had to keep going back to check while pool was refilling. Is there a way to fill a huge pool w/o the trickle autofillers that would take 2 weeks?

So when connecting the control panel to the circuit board of a spa does j1 or j2 matter? I think its a master spa part. S/n 52757***200304110140 Board mas470 master spa le m7.

Ok so after talking to a local pool veteran (45 years in biz). He said there is a water table under the area that can seep through and cause discoloration. He replastered it 12 years ago. He is going to take a look for me. I will post the results...

Black algae or stained plaster? What should I do?

got it ty

Ok so I think easiest way is to take the 2 load wires and connect them to the pump circuit breaker?

its an older system with the newer pda (pda is on/off only no rs45 cable even hooked to vs). I can just make an extra 2 wires to join the 2 hots from motor.

With my Aqualink RS is it ok to wire my VS pump to always have power? My setup only has the pda on/off functionality. I would rather the pump just run the schedule I program.

On a sta-rite heater circa 2007 can you help me? The pressure switch seems to be getting propper voltage but I get a PS error on board. Can a switch with proper voltage still fail?