Recent content by Klink00

When vacuuming my HP series pump goes to 0 and then never transitions to regular psi. We have to switch it to other settings then back to filter for it to kick back on. Is this normal? Thanks

Yes, I have the Taylor 2006 and ph test turned bright yellow. I came into the forum and asked about that yesterday but didn’t receive much response. I went to the pool store to get an actual number for the ph since it was so acidic.

Hi again! I’m treating my 27’ ABG pool’s initial fill from a well. The PH is 6 so the pool store is having me add 9lbs of soda ash. It then recommends shocking. How do I figure out how much bleach I need? I’m new to all this and want to make sure I’m doing things right. When I add the bleach...

I pulled water from my pool elbow deep. I filled the large tube to 44mL and added 5 drops of R-0004 to the tube and then inverted. I did it twice thinking I had messed up but bright yellow was the result both times. I just tested my TA and it was 70.

I haven’t added anything. I screwed up I should’ve been adding chlorine before it was full. This is literally the only test I have done. I wasn’t sure where to go from here.

I’m a brand new ABG pool owner. This is my first water test. The PH turned bright yellow. I have a Taylor 2006 test kit. I’m assuming this means that the water is very acidic. Do I need to do the acid demand test that is on the card? I’m not sure where to go from here. What other tests do I...

Hi there! I have an ABG pool which was installed on Tuesday. It’s 1/4 full (filling from a well) and the wrinkles have straightened out on the sides but I still see a lot of wrinkles on the bottom. Is this normal?? Thanks 27’ ABG SAND filter