Recent content by kennywayne34

We have one. 24 ft round. Pool factory was solid. (pre-covid). Pool has held up well/ half buried Top rails are kinda loosey goosey Seen nicer pools / seen worse.. no issues with salt would never go back to actual bottled chlorine Do yourself a favor and get a nice liner with a pattern you like

I hit the bronze button for you folks... best I can do today. Really appreciate it

Copy that i never went by the percentages it was all feel of the return but will use the percentage logic. It just seems that the heater is still just working a bit harder or slower than normal even given the OAT I'm not so much worried about the return temp as long as its efficient Nope that's...

Well I just arrived home and the temp reads 86 degrees. Up 5 degrees in 4 hours. Current psi is 10 and I would say that is a clean psi reading. When it gets to 14 psi is when I feel a clean up is necessary. (Dirty)

Thanks a bunch guys and gals. You all are really the best. I will get more detail on the clean psi and plate when I get home. Just FYI I went home for lunch and turned on the heater. The temp at 11:30 am EST was 81. I set it to the max temp of 90 and is currently running. I will be home between...

This is best I can do from work. This was early in the build and the swg and Jandy check before swg are not pictured yet. The remainder is the same from pump/filter to heater with by pass. . 2” pvc and it is buried running twenty feet to / from pool. I did this to avoid running utilities...

Negative. I just get the LO error code. Like instantly as soon as I hit the toggle switch.

Really appreciate the insight. From what I see here it’s more than likely a flow issue. I will say the return pressure is a bit extreme Any experience with turning the pressure switch dial to work with low speed on pump? I could never get it to work in fear of turning that dial too much. I have...