Recent content by jwcod

Just noticed it a few days ago after I vacuumed the pool. The spa level was low and there was no return from the spa jets.

The picture that you marked shows the equipment in pool mode with the solar on. The attached picture shows the equipment in spa mode with the solar off. The equipment that you marked yellow are a check valve and the spa return. So what are your thoughts/advice regarding the no/very low flow in...

Spa return jets work in spa and spillway modes, but not in pool/auto mode. Valves in pool/auto mode are set to return water to the pool and the spa. I have to run my pump at 2100 rpms to get even a slight return to the spa in pool/auto mode.

Jim, My filter was last cleaned in May and I plan to clean it again next week. My pump is running at 2000 rpm in pool mode. I know this is probably high, but it's the only way I could get some spillover into the pool when in pool mode. As I mentioned, there is no return to the spa in...

There is no water returning to the spa when in solar and pool/modes; but there is water returning to the spa when the spillway is on. In pool mode, the diverter valve is set to return water to the pool and the spa. The diverter and check valves seem to be ok. Not sure where to go with this...

I have solar and a gas heater. The gas heater is only used when in spa mode. Still experiencing reduced return to the spa when in solar or pool mode. Thanks for your help.