Recent content by Jtbeck419

Hi all - We bought a house with a ~25 yr old indoor vinyl pool. I’ve the last 3 years we’ve put in a new liner, new dehumidifier fan, pump, SWG, and various parts on the heater (Jandy LRZ). I will detail the issues with the heater below in case someone has advice, but at this point I’m ready...

Hello, I wanted to update everyone in case this helps someone in the same predicament. HVAC guy finally came back and took it apart and my suspicion was correct. He said the heat exchanger was about 90-95% clogged. It took him about 7 hours total to go through and clean it....crevices were too...

Thanks for everyone’s input! Let me try to clarify a few things and give a little more detail. If no interventions are made, it cycles through 3 attempts to fire up and then the control stops sending the signal for heat; hence the two flashes on the fenwal board. I think the root cause is that...

Thanks for the reply! The equipment is indoor. There are 2 interior doors, 1 exterior door, and lots of windows so I learned that I need to vent when the heater is on. The Fenwal box flashes twice after it goes though 3 cycles. attached pictures of heater and pool Room

Hello- new member here! EDIT: after more research, it sounds like I need to clean the heat exchanger. If so, what’s the best way to get to it? We recently bought a house with an indoor pool. We’ve put in a new liner and now trying to get the equipment working. The heater fires up, but gas...