Recent content by jrbarron

I am very intrigued. Thanks for sharing that! Looks compatible, and documentation looks pretty decent as well. Looks like I won't even have to run new wiring and should save about $350-400!

I let the light sit out for a while and it magically started working again. Since I wasn't able to get it open easily, I decided to reinstall it and see how long it would last. The answer was about 2 weeks. Now it's dead again. I may try pulling it out and getting it open at all cost, since...

So in short - I guess I'm stuck with the $1k non-serviceable Hayward option. I'll be sure to at least post pictures of the inside of the light if I get it apart. Thanks again for the help!

That did the trick, thank you for the info! Now I have the light out, and I think I can get it open, but I'm not overly optimistic about how reliably it can be sealed again. I don't see a significant amount of water in it, but I'm still guessing moisture caused the failure, and the all plastic...

Thanks! Not sure why I couldn't find that... I'll give it a shot tomorrow. It is a bit confusing that the niche model code in those instructions are so different from the code I found on material (niche cover or something?) left over from the construction. As for the size, I measured the ID...

Hello All! I have a 12V Hayward ColorLogic light installed in 2017 that just stopped working. I just tested the transformer, and it's still delivering 14VAC, so no issues there. I went to remove the light yesterday to see if it is serviceable, and expected to see a screw holding it in the...