Recent content by joshuazzx

Could you please share your experience on switching to the RJ-60plus? Thanks!

Thanks for the reply. Here are some update. 1. On Saturday, it was starting producing Chlorine, it increased the FC level from 2.5 to 6 ppm by running about 10 hours. CYA is around 30-35 2. On today(Sunday morning), it stopped producing Chlorine again even with 100% and no error code. I...

I think my pool is ready, I did an OCLT, lost less than 0.5ppm, there is no CC, pool water is clean this morning. I set the cell running at 100% since 7am in the morning. Upon checking the water 9 hours later, the FC level has dropped 0.5-1 ppm. It seems the salt cell is not producing any...

Hi I am currently on the Jandy iAquaLink 3.0 IQ30-RS with PLC1400 SWG, if I switch to the CircuPool RJ series SWG. Do you know if it is possible to continue using the iAqualink web interface to control the SWG? Thanks in advance

I remember before when the SWG is on, I can see tiny little bubbles coming out of the nozzle. Now, in case all generated chlorine gets consumed, should I still see the little bubble that coming out of the nozzle? which I did not see and that makes me concern about the status of the cell.

I have the TF-100 test kit refilled in Aug 2024. Thank you, will perform the SLAM and check.

Hi Expert, I have a Jandy PLC1400 purchased in May 2023(1 year and 11month old). I found it recently stopped producing chlorine as I have it run at 100% overnight for 12 hours and no change in the FC level. I wanted to confirm if it is really the cell is bad or other things. Since my last...

Just to update, there is no o-ring between two halves of the union, but there is a round rubber gasket at the end of on half, when the union is tighten, it seals on the flat surface of the other half. Another thing is I noticed this morning, there is small dripping of water at the filter...

Hi Jim, Maybe you are right. It was installed by previous owner, I am not sure where it was originally from. I would assume it was installed by the pool company who installed the pump. I cleaned the o-ring at the thread end goes into the pump as that is where I saw small leaks. I did not...

I removed the union from the pump, cleaned up the o-ring and sealing surface. Put a little magic tube on the oring and tighten it up. It stopped leaking.