Recent content by jasonhaefner

Thanks for the replies; I've been out of town and finally back. Vinyl pool. I am 99% sure the flakes are from the heat exchanger; I will get pictures this weekend to verify. The Nature2 is after the heater, so I always assumed it would not have a huge impact as its always flowing into the...

The acid injection point is after the salt cell, immediately before the water returns to the pool. Attached is a picture of the heat exchanger degrading; it flakes off into those little copper/cupro-nickel flakes. That is a bag of dirt and organic matter from my vacuum; it is full of...

Mastertemp 250HD, I will check the CFM, I have no idea on that.

We drain it below the return lines and winterize it, then refill it to prevent the liner from getting water under it. I have some wrinkles in the liner from draining and not refilling the first few years as we have a high water table, and I did not know water could cause wrinkles in the liner...

I'm so sorry about that location; that was an old username - I just fixed it. I'm in Frankfort, IL, northern IL. I understand the Nature2, I may have it pulled out when I get work done again. I know it is all grounded with copper, BUT I will check the voltage gradients, I have not done that.

Some answers, It is a 100% Pentair system with Intellitouch and all that automation: My pool company does the testing using a Taylor kit and some automation, I take water in at least weekly: The 2023 tab in this spreadsheet has all weekly results, Ph has been between 7.3 and 7.8 the entire...

My pool is just over seven years old, and I'm on my second heater and fourth heat exchanger; initially, I thought I was not maintaining my levels properly, but now I am convinced something is very wrong and cannot find answers, so I'm looking for some opinions. Saltwater pool with the Pentair...