Recent content by InyoMatt

What is the part, catalog, or model number listed on the motor label? Examples: C48L2N143, 7-177485-24, UST1072

To figure out if it is the board or the flow switch, try using a jumper. Use a jumper between the Blue and Black wires on the control unit's main board. If the light goes out then it is a problem with the switch, if the light stays on it is the board. Also, have you checked the control box is...

Until more info is provided, this is my best guess: The Waterco Micron Top Mount (valve looks different) and the Sta-Rite Pantera are the closest matches I could find.

You'll have to crack that bad boy open to figure out the problem. My first guess is there is an issue with the water management system, specifically the paddle wheel or inner feeder tubes. Going by the looks of that video (I don't have sound on my computer, so if you said the model I apologize)...

Åh min

They have a few heat pump series, do you know the model number? Can you provide a picture of the unit as well?

The APUREM does interface with the Aqualink and you should be able to control-atleast so far is my understanding. For a better explanation take a look at this owner's manual for the controller on Jandy's website: (Owner's Manual)

Hey Jimmy, I called Zodiac-Jandy to try and get the scoop, their thoughts were as such: you will need the APUREM to tie into your current box, OR replace your Aqualink with the PureLink (Jandy PureLink 14-Blade 40k Power Center - 6614AP1400 - INYOPools.com) per Ping's suggestion. Their...

Hey Mia - the Pentair can operate below 2800 ppm, all the way down to 2600 ppm before stuff gets super-bad. The major downside of running it below 2800 is a drop-off in efficiency. Also, the low-salt chlorinators do not handle large pools (yet.) So if your pool is 30K or bigger, you may have a...