Recent content by HTSC

Yes, above ground pool and yes always be a water column. And thanks everyone for your replies.

So, If I connect to both bonding lugs on the pump (as shown in the picture in housing basin and on top of pump) then I would not need to drill into the skimmer to bond the water there, correct? Since technically the skimmer and pump basin lug are basically bonding the water, while on the same...

Pump info attached. Will get better pic of pump basket bonding lug tomorrow.

Other pics

I’ve attached pictures of the bonding lug and grounding lug. I understand the bonding concept, but I don’t think I need to bond to the bonding lug at the bottom of the pump basin only (being plastic). Or is this so I don’t have to install the skimmer bonding kit? Would it be best to ground the...

Thanks got it saved.

I’ve searched and don’t think this question has been asked. My pump has a grounding and separate bonding lug. Pump bonding lug is on the plastic pool housing which would be for the water. Also my pool is a resin top and bottom with titanium walls. But will still need to ground and bond the pump...

Pump is already under the shed ready to go. Wish Id went with a variable pump.

Pool is not actually installed. Plan is next week, but I'm going ahead and having the electrical ready and plumbing stubbed to about 6 feet of the expected pool's location so just two simple PVC connections and I'm hooked and ready. Finishing up the pool's foundation now. I'll post pics once...

Morning, New to the group from SC. Made a post here. Please reply when one of you get a chance so I can get this plumbing done and the wife off my rear end. :LOL:

New 24' salt AGP install - 1.5hp single speed pump (on timer) and sand filter 30ft from pool. Running buried schedule 40 PVC. Pump and Filter have 1 1/2" connections, salt system is 2". Have purchased all 1 1/2" pipe, fittings, unions to finish the plumbing. Would this be sufficient or do I need...