Recent content by Hanstb

Thank you Marty, Unfortunately the permisible pH range on the IntelliChem is 7.2 to 7.6, I can fudge the numbers +/- 0.3 by tweaking the probes, but I like to retain that margin to more closely align the probe readings to the drop test. I set it to 7.6 for now and I'll see where I'm at in a...

Thanks Fellas, almost stepped in it there... Should I aerate the pH up to 7.8 or just leave it alone and let it naturally rise to 7.8 and the dose MA to maintain 7.7/7.8?

O' crud! The app was set to bleach, my bad. I set it to bleach when I filled the pool (because I used liquid bleach the first few days) and forgot to set it back to SWG! Is this better? (Actual & Planed)

Marty, Perhaps I have been staring at these numbers a bit too long over the last couple days, I get the following, where did I err? (One picture shows the actual test results, the other the projected values.)

Eureka! FC 5.5 CC 0 pH 7.2 TA 90 CH 200 CYA 70 (Calculated by Pool Math) Salt 3600 CSI -0.04 Temp 81F Now what? :scratch: Left to my own devices, I would hold the pH at 7.2 until TA dropped to 60, then let the pH rise to 7.4 and see how stable it is at that point, I am also slowly adjusting...

Agreed, but it's the only thing that makes sense. Unless something else was going on and coincidently stopped when I brought the heaters back online. Either way it seems to be back to normal, when I get a chance I will try and recreate the condition by setting the temperature for heat then...

I believe I have figured it out, but if I'm right, this should not be! Note: Everything is being controlled through ScreenLogic, my Indoor Control Panel is inoperative (replacement ordered), the screen failed. When I filled the pool last week, I turned the heaters off, both on the Pool/Spa...

21 gallons of MA and counting... This morning's test results are promising, I believe I will reach the goal of +/- 100 TA today. FC - 6.0 (OCLT < 0.5) CC - 0 pH - 7.4 TA - 120 CH - 200 CYA - 70 (Calculated by Pool Math) Salt - 3600 CSI - .29 Temp - 80F I am leaving the SWCG OFF today until...

B & C. A is for horseshoes and handgranades...

That’s the plan, I’ll leave it be once it reaches 100 and let it find its own way from there. Nothing at all, just a poking fun...:poke:

Good advice Gentlemen, thank you! I have my TA down to 160 and falling, I hope to have it down below 100 by the end of the day tomorrow as I will not have time after that to mess with it for several days. I have the Taylor salt test kit, so I have a one drop delta from the previous test, the...