Recent content by GriffithJerryl

I’m using RS4 controller with iAquaLink 2.0 to control Jandy ePump, Pro Series, Polaris Pool Sweep, 3 LED Lights and Deck Jets Valve. I Noticed this morning my Jandy ePump was not running with outside temp at 35. At this minute 8:01 AM the AquaLink air sensor is reporting 40 degree air temp...

Thank you both for your help. I use the Taylor K-2006 and I use a speed stir. Is the TFTestKits TF-100 a better kit for more accurate results? Only "assortment of chemicals" i have ever added over time are the same ones required for all SWCG pools, salt, acid, alkilkinity, calcium hardness...

Last year I noticed a stain developing on bottom along one side roughly 12 to 18 inches wide running most of the length of the pool and stops about 4 to 5 ft from ends. This year I noticed the stain has grown in middle deep part of the pool about 6 to 8 ft wide. It is not a solid, uniform...

Even though the picture of the new Zodiac PLC1400 3-port PureLink Cell Kit picture did not show the R0452500 Sensor Indicator Module as part of the new 3-Port PureLink Cell Kit it arrived with it as part of the new kit. The vendor just needs to update their picture. This is link...

This thread just saved me lots of grief. This forum is fantastic for people like me that can do most anything within reason like read directions on cleaning Jandy Aqua Pure PLC1400. I have been getting "no flow" for several months through the winter so I decided to clean the Chlorine...