Recent content by gregk

The picture is my SWG circuit board. One resistor is burned away. Maybe happened when or because the power cord and cell melted. Would anyone have any type of schematic? Also the watch type battery is visible in the picture, it looks a bit oxidized, could that cause any communication error of...

Hello, I am having the same issue. Did the pool people ever tell you the reason or fix for the Non Genuine error? Do you still have the contact information of the people you talked with?

It looks like the watch type battery is secured into place, there are three tiny solder points on the top contact. I did take the cover off of the unit and powered up the system. There is a tiny red LED that is always on, but also I see a location for a resistor that is burnt and has no...

Unhooking by taking the wires off? I have disconnected the power cord at the cell. What I am thinking of doing now is 1. disconnect the power unit from the power supply coming in, maybe it will reset? 2. Also there is a small push button switch inside on the read out display, I thought to open...

A new SWG system is $1700-2000 installed and plumbed. i already have the money invested in the pool and SWG.

Unfortunately the US location of Compupool is permanently closed. I have sent email to Australia (their only location) but have not received any response. I appreciate the contact information. I purchased the cell from poolsunlimited.com. I will try to get feedback from them, thanks for that...

I have replace a burned up cell and power cord. Last fall before closing the pool for the fall my SWG cell and power cord melted. I replaced the cell with a genuine replacement cpsc16 and a genuine power cord. Initially I was getting no water fault that I was finally able to eliminate by...