Recent content by grasshopah

Based on the replies I went back and cleaned all connections and replaced the switch and prayed... switched the power back on and the light works now! :party: Whew! I really did not want to start cutting the deck !! Thank you Seanhan, danpik and diyindux

The pool light of my inground gunite pool will not turn on. the light switch is hot but I do not have any juice at the deck junction box.(feeder cable highlighted in red box) The light fixture itself is brand new and I tested it to make sure that part works. The deck is about 4 ft wide and I...

Update: I did go ahead and buy the RJ-45. They took extra long to deliver, but installation was not difficult. What I did find surprising was that the SWG reported that the salt level was ok at 2800 ppm. ( I used a taylor salt test kit) So that led me to the question: Is it better to...

Re: Hayward Inground Poool Light Ross: How will a continuity tester show me where the problem is? Here are pics of the unit

I have a hayward pool light for my gunite 20x40 pool which is not working. The pool light is connected to a junction box installed in the deck at the head of the pool. The entire junction box is installed in a vinyl container set in the concrete. Both the feeder line and the pool light line...

I am replacing the sand in my hayward 244t sand filter. I noticed when I removed the lateral assembly that there was sand in the the laterals the joint between the laterals and the central pipe the hollow portion in the center where all the laterals are connected After disassembly I...

NCpool: Following your insight of salt existing in the pool, I went out and bought the taylor k-1766 kit. I used 14 drops ~ 2800 ppm before any salt was added. I performed the test twice to be sure. Did anyone else experience a reading this high initially? Is this reading normal or do I have...