Recent content by gmichal

Does anyone know the part number for the Pentair CV-24 valve stem (my terminology) in the attached diagram? I ran into the valve handle with my mower and it sheared off the stem at the outer case. Thankfully, it is only used for the waterfall and bubblers so it does not rotate automatically all...

Jim: I'm no electrical expert but thought I knew enough to draw the same conclusion: shutting down the breaker from my main house panel to the Pentair control panel should yield the same situation as a power outage. All 3 power outages have been for several hours in the middle of the night so...

A manual power cycle by turning off the breaker does not create the same issue; only happens after a power outage.

I have Pentair equipment controlling my raised spa and pool. Three times in the past year, in the middle of the night, we have lost power for several hours, every time the power returns we have found the pool pump, led lights, waterfall pump on and an automatic valve switched to where the spa...

Thank you for all of the posts. That was my first post and I thought that I was going to be notified when I received a response. Live and learn... The wires that shorted were the pool pump high-voltage and a 24VAC control wire. With the pump running 105+ degree temps, and the box mounted on the...

Have you looked at Jandy pool heaters? I have an Lxi that was installed when my pool was installed 8 years ago and not a problem yet...knock on wood.

A few weeks ago, I had my Aqualink RS-8 primary PCB go out after some wires shorted in the control cabinet. As the PCB was no longer available nor was there an alternate, I had no option but to upgrade to the iAquaLink 2.0, Rev T PCB. I followed the directions included in the upgrade kit any...