Recent content by Gizmo78163

Sorry, guys. I'm back to thinking it is the comm port on the PCBA (part #522524). The Screenlogic connection is not giving correct feedback to Screenlogic app or config on my iPhone -- ambient and water temps are off, valves don't stay put, and the IC60 is not controllable. Everything works off...

The keypad works very well at controlling the pump, so are we left with the "driver" comm connection or the PCB circuit that manages comm control? Is that something separate that can be repaired or replaced? It seems like the whole driver is replaced as one part, #356944Z, which runs about $800...

Thanks for your help and suggestions, Tom. Confirming good comm cable continuity, drawing 0.7 ohms (each, on both green and yellow lines) from comm screw terminal board side to the female connector at the pump comm disconnect under the display.

Screenlogic works alone, the IntelliChlor works alone, and Screenlogic and IntelliChlor work together. Presumably, the main card is good. The pump functions, too, just no comm. Regarding your checklist, Drew, everything is "good-to-go." My PB is out of business, and I'm just outside the 3-year...

Still, no comm. And manual operation only.

Symptoms started after adding IntelliChlor 60 and its power center and connecting the data cable between ET-PSL4 and the IntelliChlor power center. The pump data cable seems intact to the pump driver, and all other comm interface functions to the wireless screenlogic interface and the new...

Gonna make my life more simple... Here is a pic of my equipment rigging. Adding the Pentair IC60 to this long horizontal leg post-heater... what pieces, if any, can/do I move (to maybe the vertical leg off the heater)? And, can I totally cut out the tab dispenser and run the SWG vertically? Does...

Just successfully logged in. But won’t recognize my subscription. Edit: couldn’t find my Apple receipt so I guess I need to pay up and renew. LOL!

Ditto. I was just getting pool prepped this morning for the holiday weekend and BAM! Hit a wall! Standing by….