Recent content by GHG7F0

  1. G

    What is this? Maybe a sensor?

    I think I will leave in place and paint around with some careful taping. Thanks!
  2. G

    What is this? Maybe a sensor?

    Can it be removed as it seems starts making a noise when I put pressure to remove?
  3. G

    What is this? Maybe a sensor?

    I am painting my pvc and when I started to remove this it started making a weird noise so I tightened it back up. It leads to the roof so maybe a sensor?
  4. IMG_2878.jpeg

    IMG_2878.jpeg

    • GHG7F0
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  5. IMG_2877.jpeg

    IMG_2877.jpeg

    • GHG7F0
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  6. G

    PVC Tight

    Just as an update once I put glue on the pvc there was no issue getting it fully seated.
  7. G

    PVC Tight

    I’m installing my RJ45+ and it’s going ok except for one issue. When I dry fit the flow switch into the 2 inch pvc it goes in very little unlike my couplers. Will the primer and glue help this go in deeper?
  8. G

    RJ45+ Wiring

    Got it thanks again for your patience.😁
  9. G

    RJ45+ Wiring

  10. G

    RJ45+ Wiring

    If load is in the 2nd and 4th position wouldn’t you move to the left as you put right? Sorry i’m confused.
  11. G

    RJ45+ Wiring

    That helps! My box is a Aqualink Z-4.
  12. G

    RJ45+ Wiring

    Sorry but you lost me as I’m not sure which wires and which one is the line screws. 🤔
  13. IMG_2529.png

    IMG_2529.png

    • GHG7F0
    • Media item
    • Comments: 0
    • Category: Pool Equipment
  14. G

    RJ45+ Wiring

    Jandy Pro series 2.7
  15. IMG_2204_Original.jpeg

    IMG_2204_Original.jpeg

    • GHG7F0
    • Media item
    • Comments: 0
    • Category: Pool Equipment
See more
Top Bottom
Back