G
Latest activity Postings Media About
-
-
Ggctnj replied to the thread Connection from pool sub panel to heat pump.I am doing the work myself. I always check with the town once I know what is permitted under code. I’m going to ask tomorrow about...
-
Ggctnj replied to the thread Connection from pool sub panel to heat pump.Thanks for responses. I’ve read the regulations and since I have a gap greater than 6 feet with no permanent structure to secure to meet...
-
Ggctnj replied to the thread Connection from pool sub panel to heat pump.Although I could add a disconnect for the heat pump, I believe the outside sub panel, 9 feet from the heater, with a separate 50 amp...
-
Ggctnj replied to the thread Heat pump flow and pressure loss.I see now. Well I’m pretty sold on Hayward. Thx for your help.
-
Ggctnj replied to the thread Heat pump flow and pressure loss.To my untrained eye, Pentair seems to do pretty well. Hayward now quite as good, although 8-9 at 40 gpm may be workable. Not quite...
-
GI am planning on a heat pump. I cannot place it close enough to the panel or anywhere else to use a 6 foot liquid tight whip (9 feet...
-
Ggctnj replied to the thread Outdoor pool sub panel.Actually, the top of the panel would be right below the siding, putting the bottom of the panel 2 feet above ground. I’m been pretty...
-
Ggctnj replied to the thread Outdoor pool sub panel.The area where the sub panel can be mounted is 3 feet of foundation then fairly new James Hardie siding. If I can mount it at top of...
-
Ggctnj replied to the thread Outdoor pool sub panel.Thanks for the info. I assume these requirements apply to outside panels as well? Within the 6.5 vertical space, can the panel be...
-
GIs there a minimum height above ground for an outdoor pool sub panel? Also, can the sub panel be a disconnect for both the pool pump...
-
Ggctnj replied to the thread Heat pump flow and pressure loss.I’ve asked Hayward for the information, no response yet. I’ve read on some posts here that the Raypak Crosswind V 8550 might have a...
-
GI’ve been looking for any documentation on flow and pressure loss for the Hayward W3HP21405T and can’t find it. I can find it for the...
-
Ggctnj replied to the thread Heater Bypass?.Hayward HP21405T Raypac Crosswind V 8550 This question was originally in response to a post that had recently installed the Raypac...
-
-
Loading…
-
Loading…
-
Loading…
