Recent content by frogman_94

It will be 4x4 posts with corrugated steel panels insets and then we are having an artist do some artsy metal sculpture on the panels. We are also going to put the same thing around the pool to hide it.

I finally got the deck built. Next is the railing.

There is a little round plastic plug on the side right next to where the electrical cord comes out the end. I took it off but I could see inside. I'll check it again tonight.

I looked at my pump last night and did not find a bonding lug.

Thanks, I'll have to take a closer look at my pump.

Is there a separate grounding lug on the pump?

I just installed a SWG (Hayward Aqua Trol Above Ground Salt System AQ-TROL-HP) and it says to connect the bonding lug to the pool bonding system. How do you do that with an above ground pool especially a soft-sided splash pool? So I was thinking of driving a copper rod in the ground and...

I'll post my numbers tonight when I test.

No, the pool is full.

Is there any easy way to remove it?

To start, I got this splash pool last year for a steal. The liner never looked blue but I thought it was due to its age. I noticed yesterday when I vacuum it was leaving brush marks on the bottom. So I got to thinking, can I scrub the white stuff off and have a blue pool again. I got out a green...

I use the bottle I got from Leslie's and do my testing in the garage. I just wasn't sure if it was OK to dump the samples down the sink. Leslie's is good for something.

What do you do with the testing water? Currently I just dump it on the ground. My ground is just dirt for now.