Recent content by fjlugo63

Thanks to those that replied to thread. The Omni troubleshooting guide played a key part of end solution. The initial issue was traced to a faulty access point (branded Hayward/Mfg EnGenious). In the process of trouble shooting AP failure, I opted to use existing cat5 that sits within rock...

My pool has had a Hayward provided Engenius Access Point (AP) that worked fine. From one day to the other the AP won't pick-up an IP address using DHCP (dynamic) mode. In my case I ended up having CAT5 ~3-5' from Omnilogic board so I switched to hardwire. Issue occurs Omnilogic = Dynamic &...

Kilgore, Interesting. I've been battling what feels like similar tissue. My pool has had a Hayward provided Engenius Access Point (AP) that worked fine. From one day to the other the AP won't pick-up an IP address using DHCP (dynamic) mode. In my case I ended up having CAT5 ~3-5 from...

James.....cleaned cell with normal muriatic/water solution and the alarm cleared per your instructions. I want to personally thank you as I had reached out to several pool resources with no explanation or solution to problem. Frank

The cell is 11 months old. This alarm was in fact triggered day after 17 lbs. of Calcium Chloride was added to pool water. I suppose your thought is that adding Calcium suddenly triggered alarm because it registered excessive amount of calcium in filtration system? I will clean cell. Is...

Roughly 4 weeks ago. This problem popped up last Monday.

Below is screen shot using diagnostics screen. I did take water sample to LPS and it tested at 3,300 ppm (although Omni is reading it at 7,601. Thanks for reply to post.

I've suddenly run into a Hayward chlorinator error that can't be cleared. The OmniLogic alarm states "T-Cell High Current/Salt Chlorinator1". I've attached a screen shot of OmniLogic for reference sake. See bottom left of .jpg file with alarm symbol and red text. Any Forum members familiar...