Recent content by exarkun

Hah! I found the issue. Do not use decimals, only whole numbers. Thanks for looking.

Thanks. Now I at least know it is me. Maybe I'll try at my work/office and see if it works there!

As the subject says, is this working for anyone or is it just me? I enter details on each step and at the end it just spins and does nothing. https://www.pentair.com/en-us/pool-spa/education-support/homeowner-support/calculators/heat-pump-calculator.html

Just to update, I was able to get them off. I purchased this tool as it had a wider opening than many similar and it worked great. https://www.amazon.com/dp/B07MFY3HNY

I tried a needle nose but never thought of the spanner wrench! I'll give it a try, thanks everyone.

My pool has in-floor return/inlets. Recently, I have something consuming my chlorine (not passing OCLT) and after follow SLAM for quite some time I'm planning to remove both my drain and return covers this weekend and ensure it is clean under them. For the drain covers, I know I can turn off...

That plant was for trichlor, not liquid chlorine. This plant supposedly reopened in November '22. https://www.poolmagazine.com/news/grand-reopening-of-biolab-lake-charles-facility/

It is not new, I'm just putting it into use after not using it since moving into this home. I'm really baffled now. Yesterday morning, the lights exactly matched what the setting in the easytouch had (60% - 3 solid LEDs). I adjusted it down and the LEDs almost immediately changed to match...

Yes, me too. Thanks Just not sure about how much it really is outputting...

I'm adjusting on the easytouch directly. Setting to 20/40/60/80 did not cause the corresponding LEDs to move to solid. However, during testing, I noticed that the frequency of the CELL LED being on was higher at the higher percentage levels, and that the sanitizer output LEDS did change a...

Yes, the easytouch does show the salt level. My manual did not have that note about the lights slowly flashing if not at one of those settings. I'll try setting to one of those numbers and see what happens.

It is wired in, it has the power center. I can enable/disable the IC, just the percentage what I set in the Easytouch does not change the sanitizer output LEDs on the IC. The Less and More buttons are also disabled, which indicates it thinks it is externally controlled, I think... The...

When you control a Pentair IC-20 SWG with Easytouch, should the "sanitizer output" LEDs on IC-20 reflect the percentage setting you enter in the Easytouch? Mine do not match what I have set in Easytouch, hence the question... Thanks

It works! Thank you for the help.