Recent content by essbase

Yes but it would be painful...some of the run is under dirt along house. Deck is pavers.and about 20ft in.

Thanks, I have seen it on the Screenlogic app... I have just not paid attention to it. Will check.

a foot higher

Thanks James.... yeah I dont understand why you wouldn't just follow the engineering plan that was paid for.... makes no sense to me. However, they guy that did this build also put the jets at wrong heights and installed the incorrect light niches and bubbler niche. He had to jackhammer all of...

Not running at full speed (3450) I like it at about 2900... Start to see cavitation at 26-2700 or so.

Hi James when I say cavitating... It seems to vibrate/growl and I can see turbulence (lots of what look like tiny bubbles) through the clear basket cover on the pump when I set the only suction on to the SPA or the Main Drain. In pool mode I can set the 3 way between the Main and Skimmer in the...

Thanks Allen I will check the GPM tomorrow. Here are some shots of the pipes

Jim, Its a 150 sqft filter. I have cleaned it very often... Daily for the first couple of weeks. However, they didnt balance the pool water after plastering so the Calcium levels were really low. I have white deposits all over the glass tile and have been told the surface of the pool is rough...

James, Yes I think that is correct. There are 4 Waterway straight body jets.

Allen, I am in Florida and I think the FL building code included the Ansi specs 7 & 15 for pools... Some of the requirements in the code are hard to specifically understand. but even if they do require it, I am not sure which pipe sizing they would apply from the Engineering docs. Would it be...

Hi Jim, I am not there or I would snap a picture of the pad. This is the pump that is installed: 3.95THP 230V INTELLIFLO VSF VARIABLE SPEED & FLOW PUMP (PUR-10-1662) Product # : PUR-10-1662 Mfg : PENTAIR WATER POOL AND SPA INC Mfg # : 011056