Recent content by Dwiessner

2 inch pvc all around, I believe.

Hey all, My cartridge filter finally blew out. It was a no name brand that is original to the pool, the relief valve was epoxied on, and the cartridges were ready to be replaced anyway, so it's been beyond time to replace. I'm set on using cartridge again. However, I HATE the large 4 cartridge...

Lots of great advice. I do have my SWG wired on currently, so it makes sense to run the pump 24/7, at least until I get it wired up on the timer. After some tinkering, I learned 1250 runs at 150W, is enough to keep the SWG on, and circulates the pool. It's also Whistler quiet, so that's the...

You are probably right. Im probably overthinking. As far as heat goes though, would you go minimum rpm on that, as well?

Hey all, looking for advice for programming my new intelliflo pump. First, I tried running at 750 rpm (after cleaning filters) and see very little flow. Not enough to activate the SWG, and not enough to skim. I am now running 1500 rpm for 14 hours, which activates the SWG and keeps the top of...

Nvm, reread instructions. I was using program 1 vice 2 and 4 for ext control. Thanks.

Hi all. I got my new pump and controller in, but operating them seems more complicated than installing them, Haha. I have a 18000 gal pool. I set the pump schedule to use speed 5 (1250 rpm) from 6pm to noon, just to keep the water circulating. I set it to use speed 6 (2100 rpm) from noon to 6...

Looking closer, it appears the two black wires come in from the timer, and the two red wires go back out to different terminals on the timer. So my hunch is, the two labeled black in and black out should be wired to one terminal on the solar touch, and likewise with the red in and red out?

And here is the solar touch panel, for reference

Hi all. Getting ready to install my new solar controller. The new solar touch appears to have 2 inputs. My old controller has a bunch of wires. Anyone know which of these wires should go where?

Well... I think it's done. I'll wait a few hours and try starting it up. Thanks a million for the help!

It's a fiberglass pool. On the deep end, it has a few jets. I can switch from the normal inlets, jets, or water feature by turning a few valves