Recent content by doellg

This thing will not help your pool. All it does is restrict the opening at the top of the basket to make the water speed higher AT THE MOUTH OF THE BASKET. Everywhere else, water velocity and volume is unchanged. The water volume actually entering your skimmer from the side of the pool is...

Figured it out. I had the low voltage control line from the heat pump connected to the "heater" terminal on the Intellitouch controller board. Apparently it needed to be connected to the "gas heater" terminal. That was counter intuitive to me, but made the change and everything works fine.

Thanks for the reply and suggestion. Gave it a try unfortunately heat pump still runs whenever water is flowing, even when heat mode is set to off and when temperature set points are set well below current water temp. Air and water temp sensors both read accurately.

Just installed a Pentair Intellitouch automation system to control my 8 year old IG pool. Valve, light, pumps controls and thermostats, everything worked flawlessly when I fired up the Intellitouch, EXCEPT the control of my AquaCal Heatwave heat pump. I connected the two wire low voltage...