Recent content by dmcconnell68

Thanks Steve for the suggestions. I do tend to leave the robot in the pool, but when I do take it out and put it on the caddy, I do always wrap the cable the same way on the holder and leave pretty big loops (almost touching the robot.) I'm thinking now that it stopping mid cycle, might be...

I'm wondering if anyone else has experience issues with a Dolphin Active 30i or similar pool cleaner. Issue 1: Sometime, more often than not, the cleaner does not run the full cycle. Sometimes it will run 30 minutes, sometimes an hour and then it just stops. The controller is still on like...

Can anyone tell me if CPC Hybrid Sealant is an acceptable grout for tile on a fiberglass pool? Thanks, David

The waterline tile was just installed a couple weeks ago, the pool has been in since September 2017. What you see on my pool is approximately 6", each square is approximately 1" plus the spacing. They dropped the water level in my pool maybe 5" below the bottom of the tile.

We went with National Pool Tile, the specific tile is called Mix Ocean - Ocean Blend. Here are some pictures.

They finished our tile install last weekend. We ended up going with a 1"x1" porcelain tile that was thinner than glass tiles. I was concerned that the concrete overhang in out pool might not be enough for the tile to go under but it was fine for tile we picked. I'm not sure that the glass...

Just had tile installed on fiberglass pool and I'm noticing some dried clear silicone on some of the tile. What is the best way to get that off? Will muriatic acid remove it without damaging the tile and grout? Thanks, David