Recent content by dlnagold

Thanks, had to unexpectedly go out of town, I will run those tests and post as soon as I get back. I don’t think it is any kind of Alger growth because we just drained the pool, had it resurfaced and it is doing the same thing at startup. I have put de powder in the skimmer, this time I used...

Hi, I have been searching here and have not seen an issue similar to mine, so if there is already a thread about this i apologize. I have a Hayward 4800 series DE filter (new home to me, pool is almost 30 years old, and label is gone from filter). I have already replaced the manifold, o-ring...

Yep, put a new bead on it and am good to go, producing chlorine again. :)

You guys are so awesome, took off the board and look what I found:

Thanks so much, if the weather holds out tomorrow, I’ll take the board out and look at it and post my findings. Thanks again!

Thanks, is there more than one relay? Or is it probably something that I will definitely notice? Also, if that was the case, wouldn’t I also see one of the errors that others see when the K1 relay goes bad? (I think it is no flow or no cell power)? Which I don’t see.

Yes, I do get the same results

Thanks, I’ll take a look at the board tomorrow, as I have tried the + button already to no avail

Yes it is aqua logic

Yes, those are the numbers when I have the filter in the on position (Auto) What other diagnostics are you asking for? and no, I get no "no flow" reading, and my Check cell light is not on. That is what makes this case weird to me. I have flow

OK, I have a problem that I cannot find the answer to. I have an AquaRite system, and the diagnostics read the volts +32.26v but the amps read +0.0A and 0000PPM. I bought a new salt cell T15, installed it, and I get the same thing. Any ideas?