Recent content by dfwnoob

While there's no good way of testing either of these that I know of, it really does seem like there is an issue with either the MCU board (the clip-on board which is comprised of the firmware and CPU) or the PCB itself. I can't find anyone who has experienced similar issues, only the opposite...

Hello, welcome to TFP! Just to clarify, you're saying it will go back to Auto after only 10 seconds with no other intervention at all? When you upgraded to iAqualink 3.0, did you replace the entire PCB (the outdoor board with all of the buttons on it)? I ask because the board you're showing has...

I'll do that. Looks like there are actually multiple spots that are delaminating on the "sunning shelf" or whatever you want to call it. Argh. I actually can't tell if that's gunnite underneath or another plaster. Given how insanely thin it seems to be, I'm leaning toward it being maybe being...

Message received! I’ll only have to drain the pool down a few inches anyway. I’ll just do that and wait until I patch it to fully get my water chemistry in order. Thanks for the advice.

Searched and actually found a few positive reviews of the E-Z Patch stuff here on the forum. The 1FS kind looks like it can be used underwater, so I can go ahead and fill the pool all the way back up and not have to either keep it low or re-drain some when it gets here. Doesn't appear to be any...

Well, the spa/spillover is now rebuilt! Unlike before, there is now an actual "second wall" for the brick to attach to. I'd say it certainly looks much better now than before. I think he did a nice job on the brickwork, and he reset two of the big flagstone pieces on the top that were loose...