Recent content by dasbad

Sorry this was an accidental post

Aquarite is the SWG. I just cleaned the cell (minor build up). After reconnecting everything and turning the unit on the Inspect Cell was flashing and it was generating. Then it turned to Check Salt to red, Inspect cell to solid orange. I’m guessing it is because the salt content is too low now

I must admit I haven’t been as diligent of testing the pool since the winter temps dropped here in Houston. I just did a test and it seems a bit out of balance. Specifically my salt content dropped significantly. There was quite a bit of rain here in the fall and winter so I’m sure this is...

I must admit I haven’t been as diligent of testing the pool since the winter temps dropped here in Houston. I just did a test and it seems a bit out of balance. Specifically my salt content dropped significantly. There was quite a bit of rain here in the fall and winter so I’m sure this is...

My overnight test seems to be pretty stable. I’m starting to think I lose it during the day. Maybe CYA is too low? I wonder if I should do a quick SLAM before adding CYA just in case

Here are the results: Off: 2900 88 31.6 0 54p 0 Al 0 R 1.59 E-9 Auto 2900 88 26.6 4.78 54p -3100 Al0 R1.59 E9 Off 1 to auto 2900 88 27 4.73 53p -3000 Al0 R1.59 E9 Salinity:3900 Taylor kit Swg serial *3A0909-1011327* Cell serial 4E22238-201557

Hi, I have a Hayward Aquarite with a tcell925. I feel like my fc is dropping too quickly with CYA of 50 and SWG set to 70% for 8 hours. This is the diagnostics on the panel: 3000, 87, 31.7, 0, 48p, 0, al0, r 1.59, e 9 Any help is greatly appreciated! Thank you

I think I finally got my testing right…

Todays test…

I’m using the Taylor k 2006. I’ll redo another test tomorrow to see what results I get.

Have a little bit of green algae growing that ive been scrubbing away daily Any suggestion highly appreciated. First time testing so may be small inconsistencies.