Recent content by daddydolge

I have a little workshop and happened to have some already. I would post a picture but I already have put the entire system back together. If it helps I can describe exactly where the fuse is. If you flip the main board down towards you the small glass fuse if on the back of the panel, top...

I can't thank you enough, saved the day! Found the fuse (very small and well hidden). All back together and running again! MANY THANKS!

Thank you! Do you know where I can find a picture of this 3.15 amp fuse? I have looked all over the board and see nothing!

Hi everyone! I think I screwed up and will try to make the back story as short as possible. I have an AquaLink RSA panel with 2 Jandy JVA2440's to control between the pool and spa. One of the Jandy's were acting up so I took it off and put the handle on the valve so I could manually switch it...

Hmmm, I see what you mean! We are in the middle of a nasty storm here in CT so I will try to post chemical tests later this weekend. Thanks for your help!

Hi Jason! It's not dirty, the pool is nice and clean, no dirt settling....but when a leaf lands in the pool (or goggles or anything for that matter) and settles to the bottom, if I don't get it right out when I finally do the floor underneath it is sparkling blue! I have an in floor...

Hi everyone! I have an inground pool (35,000 gallon), I believe it is gunite. The pool is blue and I am having some weird issues. It just doesn't seem to "POP" anymore! My daughter left a pair of goggles in the pool for 2 days and when I took them out, the floor underneath it was nice and...

I ran a wire direct above ground in it's place to check and the wiring is just fine....still just spins and spins. And yes, the lid is in perfect shape and I do put it back on since the sensor is light sensitive. I honestly don't know what else there is to possibly check?

Well, I received the new PCB board (the last one was defective) and replaced it...still nothing!!! The system just continues to spin, never stopping at a station, and the transition indicator just stays lit to remind me that the Dang thing isn't working. I have tried everything now!!! New...

Yeah, and I am in CT and summer is almost over here :twisted: They just sent the PCB board...they said that is what it must be since we have already tried everything else, including 3 sensors

Thanks Tom! I agree, they didn't seem to know what the heck they were talking about (after almost an hour on hold). Mine has the sensor that reads where the plate passes through the sensor itself. I actually found that troubleshooting guide as well but I haven't found it very useful since...

Tom, to answer your question....no, it does not look like that. It is the older model, the UltraFlex1...the sensor looks different and the plate does not have holes in it. I spoke with a pool company yesterday and they are going to send me another board. Apparently Polaris doesn't make the...

Ok, well...I received my new UltraFlex PCB Replacement board (which is different looking than my old one) and wired it in per the directions, matched colors etc. I turned the untit back on and it started smoking. The brand new board is fried. I checked my wiring and I did it exactly how the...