Recent content by cssnms

We pulled ahead last night, only to be passed yet again today. :mad: We need another TFP photo 'like' push to get us over the hump! Voting closes tomorrow.

Thank you all who liked the photo. We are down by 1 like with a couple of days to go!

Our pool builder is having a photo contest. Our pool is in 2nd place with likes. Would appreciate any help from the community. We plan to give the prize to a family that is going through a difficult time. https://m.facebook.com/photo.php?fbid=1093731939427588

Mine still works and still can't get out of the deep end when running in the side to side N pattern. It's half the price of the Dolphin and only cleans half the pool. :rolleyes:

It is not any good if your pool has a deep end. It will get stuck on the incline and not finish cleaning your pool. It wonders in nonsensical patters esp in wall and floor mode, missing lots of areas so it misses lots of areas leaving debris behind. Read this thread, lots of information and...

I wouldn't buy it for even $375

I thought I'd double up the cleaning effort today so I recharged the S1 and dropped it in the pool on floor/wall mode to see if it would pick up the rest of the leaves... That would be a big NO. It left half of the leaves seen above behind after running randomly for 3+ hours. Interestingly...

Well my S1 woke up this morning in Eco mode where it last stopped stuck on the incline. And today it never left the incline as it repeatedly went back and forth over the same line for its entire cleaning cycle. So not only did the shallow end not get cleaned, neither did the deep end. Here...

Mine is smart enough to park itself on the incline where it gets stuck and eventually runs out of battery life. :brickwall:

I've had to drain off my pool recently due to heavy rains and to do so, I unravel the discharge hose and run it to an area to drain. Well when I turn the pump and that Dang hose filles, it's like trying to wrestle a giant serpent. If I let go the hose comes alive! :shock: Is there a better...

Unfortunately Aiper still has some work to do on the programming. Today I ran my bot on floor/wall mode. It ran for +/- 3 hrs. Towards the end of its cycle it was running in the side to side N pattern and unfortunately it got stuck on the incline. I'm guessing it had something to do with it...

Did you try going to your intellicenter control panel and resetting up the pump in there?