Recent content by clmsntiger1

  1. clmsntiger1

    Doheny's Discovery, S200, Active20, Triton owners club

    Re: Doheny's Discovery, S200, Active20, Triton owners club Thanks for the clarification. I'm trying to decide what I'm gonna do. I really like all the great feedback from the Discovery. I have a rectangular pool with entry steps and that's it, no other special features. In your opinion, do...
  2. clmsntiger1

    Doheny's Discovery, S200, Active20, Triton owners club

    Re: Doheny's Discovery, S200, Active20, Triton owners club This Nautilus looks similar to the Discovery. Is it the one that's a twin? Or is it the more expensive Nautilus Plus with Clever Clean? http://www.amazon.com/Dolphin-99996323-Nautilus-Robotic-Cleaner/dp/B01N78IVWJ?th=1. I see...
  3. clmsntiger1

    White water mold

    Thanks for the response! I'll just be ready to jump on a SLAM as soon as I open.
  4. clmsntiger1

    White water mold

    I bought my way into a pool last summer and started out using the TFP method and had a pretty good summer. I closed the pool myself at the end of last season and I think I did everything I was supposed to. It's a warm day here and I decided that I would have a look at the water so I pulled...
  5. clmsntiger1

    pH Level for SLAM'ing

    Thanks for the replies! It sounds like it doesn't adversely affect the actual process of killing the algae unless the pH gets really high, but could impact the clarity of the water or cause staining.
  6. clmsntiger1

    pH Level for SLAM'ing

    I have a question about pH level for SLAM'ing. I know pool school calls for a pH between 7.2 and 7.5 before starting the process. How does a higher pH (7.8 for instance) affect the SLAM process?
  7. clmsntiger1

    Dirt/Debris/Dead Algae Daily

    Sorry, I forgot to add that I do currently add DE to the filter. But thanks for the reply, it does help to see that I'm not the only one! I'm currently looking for a robot as well to help out with this.
  8. clmsntiger1

    Dirt/Debris/Dead Algae Daily

    Ok here's the deal. Nearly every day I have an accumulation of dull green to brownish debris on the bottom of my pool. I vacuum it all up and it starts accumulating again. When stirred up it poofs into clouds. The water is otherwise crystal clear. I have been seeing this for at least a...
  9. clmsntiger1

    pH just shot up

    Thanks for the responses! I'm gonna head to Lowes and pick up some muriatic acid because I don't have any on hand. I'll wait to add it until my FC drops further to be more accurate. Sent from my SM-N920V using Tapatalk
  10. clmsntiger1

    pH just shot up

    I've got a situation that I can't figure out. This is my first summer with a pool and using the TFPC method. So far I've been able to keep my pH consistent for the last couple months with little maintenance. It always slowing drops and I add borax from time to time to raise it, it's never...
  11. clmsntiger1

    Algae in pool

    Re: Algae Bloom The pool is clear in the shallow end and has a slight green tint in the deep end. I can still see the main drain in the deep end though. I was only considering using the cover so that my FC loss wouldn't be as high each day, but I see what you're saying. I bought some pucks...
  12. clmsntiger1

    Algae in pool

    If I have a sand filter can I just leave it on filter mode? Or is recirculate the best when slamming and if I'm going out of town?
  13. clmsntiger1

    Algae in pool

    Should I load the floaters full of tablets? I guess that would be best cause I can always take whatever is left over out when I get back. Shouldn't raise my CYA too much.
  14. clmsntiger1

    Algae in pool

    I have been following the methods described on this site since I opened my new pool the first of May. I've had no problems at all maintaining crystal clear water, that is until today. I just took the solar cover off and found a lot of algae in the pool. The cover was put on Sunday evening and...
  15. clmsntiger1

    Replacement motor or new pump?

    Here is a picture of my current pump. The pump housing is a Hayward model SP2610X15. - - - Updated - - - Here is a picture of the full setup.