Recent content by clg82

CBS?

Hello everyone, I'm trying to find some help wiring both my spa and pool light to the same circuit in my EasyTouch automation panel. I can't for the life of me find a schematic showing the actual wiring from the breaker, to the panel, or the GFCI outlet to the terminal for the circuit. Any...

Not sure what you bean by ET, but my iPhone does have the ScreenLogic app...

thank you Jim, I will move forward and adjust as needed based on everyones suggestions, one last question, on our prior home with this exact same automation system there was an Alexa skill that I could use within the hope to set the spa temperature, turn on pumps etc......but I can no longer...

If I connect the booster pump to that “spa” circuit, can I turn the booster pump on and off as I please without affecting the heater, and the pool pump that actually feeds the spa, I guess the better question is, does that “spa” circuit act like all other circuits and I can turn the booster pump...

Thanks Jim for your helpful response, first off we were worried that running both lights to the same relay would be too much for the relay so it’s nice to hear that we can have them both going to the same relay. As far as the spa goes, I’m wanting to turn the booster pump on from the spa with...

Attached a picture of the pumps for reference, the pump on the right is the “booster pump” and the one on the left is the actual pool pump.

thank you for your quick response OGDENTO, the booster pump is specifically made to shoot extra air into the spa, but it does look like another actual pool “pump”

Hello everyone, my current pool has a pool pump, booster pump, 2 lights (spa and pool), and a pool/spa heater. I purchased the Pentair EasyTouch 4 automation system, after speaking with the installer he mentioned I couldn’t use the booster pump with the easy touch because I didn’t have enough...

On a side note where do you prefer the switch on the back of the actuator?

Ok everyone I'm back again early. I found where the temperatures are on my easytouch. The solar temp is 80 degrees. The water temp is 76 degrees. The outside temp is 67 degrees. Is that enough variance between solar and water for it to turn on the actuator? - - - Updated - - - To answer my own...

Right on everyone.....well I will see if the solar turns itself back on next week when it's supposed to get back into the 90 degrees around here.....will report back my findings sometime next week....

Re: Actuator solar valve quit functioning... this may be my issue.....it has been relatively colder out during the afternoon than it was when I first changed the schedule.....so if the solar temperature isn't hotter than the pool temperature the valve won't turn on? and adjusting the "target...

Re: Actuator solar valve quit functioning... Now i'm thoroughly confused lol......so what is the screenlogic app setting the temperature too when I adjust it for solar heating on the pool? is it reading off of the temperature that the sensor is saying on the roof? I will double check to see...