Recent content by clairsan2023

This was the solution that I also came up with and posted earlier although mine was to determine when the freeze protection started and cycle the spillover during the pool mode time. With Jandy you could set up the Program B for just the spillovers suggested by DrewLG and then when you know it...

Not sure if your response was to my program schedule post but if so I only run this program during freeze protection so the pump has already been primed and is running. The only thing I’m doing is changing the return valve to send some water back to the spa return when in pool mode. This is...

I have the same issue with our Jandy system. In the past winters I’d have to manually turn on the spillover about every 4 hours while in freeze protection to add water back to the spa. I had to time this during the 30 minute pool mode cycle as spillover doesn’t work for me on spa mode without...

I agree changing the cam as a temporary solution is not ideal so my hack was to see how long it took in freeze protection running before the spa level was close to the spa jets requiring the spillover to replenish the spa level. For me this was about 5 hours so in my "hack" to be conservative I...

Thanks,

I would love to know how to do that. I spoke with the reps at Zodiac about iAquaLink and they told me you can’t get spillover into the freeze protection protocol. Did you do anything special to hack it? Please send me a screen shot of what you have on the freeze protection options. I can’t find...

I had to leave the label as Filter Pump as it didn’t seem to work with the label Pool. Not sure why but everything is fine now.

@voidpointer - so while your pool is in freeze protection mode is your spillover schedule still working? I have the same issue with the spa level dropping about 1/2 inch with each 30 minute transition from pool to spa and back during freeze protection for my Jandy ePump. My experience for the...

@greggjess - by no means am I pool expert but my freeze protection is set at 2500 rpms. I'm not sure what the correct RPMs that freeze protection should be set. My pump is a Jandy ePump series. Could 1000 be too low?

This has been an ongoing nightmare for me each winter and it seems many others suffer from this as well. Our spa is elevated higher than the pool. When the diverter valve moves via the actuator from pool to spa, the water in the spa will drop about 1/2 an inch each cycle moving the water to the...

Guys - can't think you both enough for your responses.

So I reset the aqualink circuit breaker and changed the labels and timing and so far it seems to be working. The status shows the pump is running at the 2150 rpm set for the low speed and it just switched to high speed per the program schedule and now it shows at 3200 rpm. Thank you so much...

so based on your schedule, is your pump on almost 24 hours - 2:00 pm until 1:45 pm?