You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
C
ChrisABS replied to the thread
Plumbing Parts.
Insert for returns. Looks like 1.5”
-
-
C
Got it figured out. I used standard configuration option at 1st. Used advanced this time and everything went smoothly.
-
C
You can use the connection spa de for the spa temp sensor and I believe there is also a connection for solar as well
-
C
I know that. I was saying I have a bunch of sensors left over because most systems only use 2 but they always send 3.
-
C
I get that. I probably need to just skip the heater portion because it comes up before all the sensors and then come back and add it.Or...
-
C
The plan is to swap sensors. If that doesn’t work. I’ll put the pump in stand alone get water moving to see if in fact the air temp is...
-
C
That is from a regular Aquarite S3. I have the Omni version which uses the controller instead of the tiny little display. I didn’t get...
-
C
The sensor has no way of knowing if it is in water. The sensor just reads resistance.
If the water is not flowing, the resistance and...
-
C
I have been to Hayward training a few times. I just wanted to know if the sensor selected for water had to actually be in water… 🤷♂️...
-
C
Yeah everything hooked and in the right spot. I haven’t switched out the sensor yet to see if it’s bad.
-
C
Good idea. I hope it’s not the board
-
C
Do you have a 10K resistor in your toolbox? If so connect it to the water temperature sensor screws to fool it into thinking the water...
-
C
I have installed the Aquarite S3 Omni at my house finally! Going through programming and I get stopped trying to do the heater. It says...
-
C
Yes. I don’t think you can double tap to the same relay and have both transformers running. So it will be a little different setup than...
